-
Grooved Check Valve
The TYCO Model CV-1F Grooved End Swing Check Valves are compact and rugged swing-type units that allow water flow in one direction and prevent flow in the opposite direction.
View Product Datasheet
QR 525.00 – QR 1,245.00View Options -
Wet Alarm Valves
The TYCO Model Alarm Check Valves are intended for use in wet pipe (automatic sprinkler) fire protection systems.
View Product Datasheet
-
Ducted Split Air Conditioner
Low height air handler with side-discharge condensing unit Anti-freeze temperature sensor is provided on the coil against freezing during abnormal operating conditions.
Microprocessor Based Controller Filter drier is supplied loose as standard accessory Removable panels at the bottom of the unit that are provided for service access .
Quick connector for interconnecting communication cable (10 meter Long) from main controller to Controller User Interface Metallic Condenser fan blades and evaporator blower ensure safety & high durability .
High Pressure and Low Pressure safety controls are a standard feature on all the models
2T,2.5T,3T,3.5T Download Brochure
QR 3,750.00 – QR 7,650.00View Options -
Wall Split Air Conditioner
Developed with environment friendly R410A refrigerant. R410A refrigerant is highly efficient and has an Ozone Depletion Potential (ODP) of 0.
Super Quiet: The in-built additional temperature sensor in the remote controller monitors the surrounding temperature. Therefore, the air-conditioner can adjust the room temperature more accurately and provide extra comfort to users.Quality rating : 6 star
- Inner-grooved copper tube
- Safety Design
- Leakage Detection
- Sleep Mode
- Vector Precision Air Supply
- T3 Tropical Compressor T3 Tropical Rotary compressor for high-efficiency and operation up to 52°C
Rust-proof - Flanging Processed Plate Metal
- Valve Protection Cover
Introduction Download Brochure
Performance table & selection Download Brochure
QR 2,375.00View Options -
Test and Drain Valve
The test and drain valve complies with NFPA13 sprinkler systems. Inspector’s test and drain unit w/on-off unit with brass sight glass. Female NPT inlet and outlet cast brass valve.
View Product Datasheet
QR 595.00View Options -
Pipe Insulation – FSK Faced
KIMMCO-ISOVER’s produces a wide range of glass wool-based pre-formed pipe sections; designed specifically for the insulation of HVAC pipework.:
Faced with FSK – Pipe sections, with a factory-applied reinforced Aluminum foil covering (FSK) incorporating an overlap. Performed sections of glass fibers bonded with a heat-resistant resin, free from the shot and coarse fiber, light, damage-resistant, easy to handle, cut, and fit. The sections are split along their lengths to provide a hinge for ease of fitting.
Standard length: 1.2 MTR
View Product Datasheet
-
Rubber Insulation For Duct – ...
ARMAFLEX CLASS O (AC) RUBBER INSULATION
Insulation/protection to control condensation, reduce energy loss and protect against frost for air ducts, vessels (incl. elbows, fittings, flanges, etc). Suitable for air HVAC Ducts and is available in various thicknesses & options with and without factory-applied self-adhesive property.
View Product Datasheet
-
Rubber Insulation for Pipe – ...
ARMAFLEX RUBBER INSULATION CLASS O (AC)
Insulation/protection to control condensation, reduce energy loss and protect against frost on pipes, air ducts, vessels (incl. elbows, fittings, flanges, etc). Suitable for hot and cold water services, chilled water lines, heating systems, air conditioning, and refrigerated pipework
Note : Standard 2 meter length unit Qty , Price is per Mtr
View Product Datasheet
-
Pipe Insulation – Aluglass Faced
KIMMCO-ISOVER’s produces a wide range of glass wool-based pre-formed pipe sections; designed specifically for the insulation of HVAC pipework.:
Performed sections of glass fibers bonded with a heat-resistant resin, free from the shot and coarse fiber, light, damage-resistant, easy to handle, cut, and fit. The sections are split along their lengths to provide a hinge for ease of fitting. Aluglass facing ensures zero water vapor permeability, puncture resistance, and eliminates the need for external weather protection
View Product Datasheet
-
Rubber Insulation for Pipe -AP
ARMAFLEX AP RUBBER INSULATION
Armaflex AP Insulation/protection to control condensation, reduce energy loss and protect against frost on pipes, air ducts, vessels (incl. elbows, fittings, flanges, etc). Suitable for hot and cold water services, chilled water lines, heating systems, air conditioning ductwork, and refrigerated pipework. This grade of Insulation has in build micro ban antimicrobial technology & has better fire properties and complies with ASTM E-84 standard.
Standard Length: 2 Mtr pc Qty ,Price is per Mtr.
View Product Datasheet
QR 10.15 – QR 31.53View Options -
Upright Sprinkler
The TYCO Series TY-B, 5.6 K-factor, Upright (TY315) Sprinklers are standard response, standard coverage, decorative 5 mm glass bulb type spray sprinklers designed for use in light, ordinary, or extra hazard, commercial occupancies such as banks, hotels, shopping malls, factories, refineries, and chemical plants.
- All hazard
- Discharges a hemispherical water spray pattern in the area beneath the sprinkler
- Small frame, narrow profile bulb
- Designed for use in light, ordinary, or extra hazard, commercial occupancies such as banks, hotels, shopping malls, factories, refineries, chemical plants, etc.
View Product Datasheet
QR 24.40View Options -
Sidewall Sprinkler
The TYCO Series TY 5.6 K-factor, Horizontal Sidewall Sprinklers are standard response, standard coverage decorative 5 mm glass bulb type spray sprinklers designed for use in light and ordinary hazard, commercial occupancies such as banks, hotels, and shopping malls.
- Light hazard/Ordinary hazard
- Small frame
- Unique deflector design of the horizontal sidewall sprinkler results in smaller profile
- Designed for installation along a wall or the side of a beam just beneath a smooth ceiling
- Water discharge is directed primarily outward and downward in a quarter spherical pattern
- Sidewall sprinklers are often used in lieu of standard pendent or upright sprinklers due to building construction, economic considerations, or aesthetics
- Special deflector on the vertical sidewall sprinkler allows it to be installed in either a pendent or upright position
View Product Datasheet
QR 29.00View Options -
Butterfly Valve Grooved End
The TYCO Models BFV-300 and BFV300C Grooved End Butterfly Valves are indicating type valves designed for use in fire protection systems where a visual indication of open or closed valve condition is required
- Designed for use in fire protection systems
- UL and ULC Listed
- FM Approved
View Product Datasheet
-
Roof Exhaust Downblast
FCS -D (Direct drive) & FCS -B (Belt drive) fans are ideal for general purpose exhaust applications including bathrooms, garages, general kitchen areas, offices, churches, dormitories, factories, large warehouses, and other relatively clean air applications. They feature a weather-resistant, seamless spun aluminum housing which works in conjunction with a patented wheel design and deeply spun inlets to provide smooth quiet airflow through the ventilator. The centrifugal wheels are aluminum, non-overloading, backward inclined, robotically welded, and dynamically balanced
View Product Datasheet
QR 2,950.00View Options -
Plate Mounted Axial Fans
The QCM series are axial fans suitable for application on wall or panel in residential, commercial and industrial building.
View Product Datasheet
-
Trim Vertical Closed Drain Co...
The TYCO Series “Royal Flush II” Concealed Pendent Sprinklers Quick Response (3-mm bulb) and Standard Response (5-mm bulb), are decorative sprinklers featuring a flat cover plate designed to conceal the sprinkler.
The TYCO Model RC-1 Retard Chamber is required in installations that will be subject to pressure variations, as are generally associated with public water supplies, in order to help prevent false alarms.
- Quick & Standard Response, Standard Coverage
- Designed to conceal the sprinkler.
- UL Listed and FM Approval
View Product Datasheet RFII
QR 1,260.00View Options -
Gravity Shutters
Gravity Shutters avoids heat loss and entry of wind, rain, and birds. The fins of the shutter are opened by the airflow when the fan is working and they close down by gravity when the fan is switched off.
View Product Datasheet
QR 295.00View Options -
Concealed Pendent Sprinkler
The TYCO Series RFII 5.6 K-factor, “Royal Flush II” Concealed Pendent Standard Response (5-mm bulb), is a decorative sprinkler featuring a flat cover plate designed to conceal the sprinkler. These sprinklers are optimal for architecturally sensitive areas such as hotel lobbies, office buildings, churches, and restaurants.
Each sprinkler includes a Cover Plate/Retainer Assembly and a Sprinkler/Support Cup Assembly.
View Product Datasheet
QR 32.00 – QR 48.00View Options -
Pendent Sprinkler
The TYCO Series TY-B, 5.6 K-factor, Pendent (TY325) Sprinklers are standard response, standard coverage, decorative 5 mm glass bulb type spray sprinklers designed for use in light, ordinary, or extra hazard, commercial occupancies such as banks, hotels, shopping malls, factories, refineries, and chemical plants.
View Product Datasheet TY3251
-
JERSEY ALUGLASS TAPE 3″
Jersey Aluglass self-adhesive tape is a premium quality tape, specifically built for Aluglass Insulation products in the HVAC industry. High-quality products are used for its construction like a thicker gauge of aluminum foil, FR Glue, Glass cloth with a high yarn count backing, solvent-based adhesive & and easy release silicon paper.
View Product Datasheet
QR 8.00View Options -
-
Centrifugal Roof Extractors
Centrifugal roof fans are designed for direct or ducted ventilation in residential, commercial, and industrial buildings. they are designed for easy installation, high-efficiency low noise levels. The motor is outside the airflow, this allows the fan to exhaust clean or slightly dusty air with temperature
View Product Datasheet
QR 2,296.00View Options -
Deluge Valve, Diaphragm Style
The DV-5 Deluge Valve is a diaphragm style valve that depends upon water pressure in the Diaphragm Chamber to hold the Diaphragm closed against the water supply pressure. These valves are to be used only for hydraulically calculated systems.
View Product Datasheet
QR 3,882.00View Options -
Centrifugal In-Line Fans Roun...
The AXC LINE-METAL is a series of centrifugal in-line fans with the advantage, typical of axial fans, to convey air along the same axis of the impeller
View Product Datasheet
QR 372.00View Options