- Sort by latest
Function: Designed for supporting pipe runs from strut supports.
Approvals: Underwriters Laboratories Listed for B2400-3/4″ thru B2400-8″. Conforms to Federal Specification WW-H-171E & A-A-1192A, Type 26 and Manufacturers Standardization Society ANSI/MSS SP-69 & SP-58, Type 26.
View Product DatasheetQR 37.80 – QR 44.80View Options
The Potter PS10 Series Pressure Actuated Switches are designed for the detection of a water flow condition in automatic fire sprinkler systems of particular designs such as wet pipe systems with alarm check valves, dry pipe, preaction, or deluge valves.
View Product DatasheetQR 276.00View Options
The OSYSU is used to monitor the open position of an OS&Y (outside screw and yoke) type gate valve.
The Model PCVS is a weather proof and tamper resistant switch for monitoring the open position of fire sprinkler control valves of the wall and yard post indicator and butterfly typesQR 333.00 – QR 410.00View Options
Elbow Malleable Iron
Elbow are used to change the fluid flow direction. It is used to connect two pipes with same or different nominal diameters, and to make the pipe and thus the fluid direction turn to a certain direction of 90 degree.
View Product DatasheetQR 6.80 – QR 175.00View Options
Water Flow Switch
The Potter VSR is a vane-type Waterflow switch with a non-corrosive insert for use on wet sprinkler systems.
- The Potter VSR is a vane type water flow switch with non-corrosive insert for use on wet sprinkler systems.
- It is UL Listed and FM Approved for use on steel pipe.
- Non – corrosive sleeve factory installed in saddle
View Product DatasheetQR 333.75 – QR 418.06View Options
Fire Alarm Bell
A fire alarm is a unit made of several devices to warn people about a possible fire, smoke, or carbon monoxide occurrence in the area of coverage
- Thermoplastic Base
- High dBA Sounds Output
- Low Power Consumption
- Quick And Easy Installation
View Product DatasheetQR 177.00View Options
Loop powered Siren
Loop powered and controlled sounder for Securiline extended.
- 3 Signal tone (DIN 33404, Slow Whoop and 990 Hz pulsed)
- Signal tone controlled from the FACP depending on the event
- Configurable volume high/low
View Product DatasheetQR 315.00View Options
Replacement Break Glass
Double Action Stations (Breakglass) requires the operator to strike the front-mounted hammer to break the glass and expose the recessed pull lever. The pull lever then operates as a single action station.
- Replacement break glass
- Non-Coded, Non-Addressable Manual Stations; 2099 Series Single and Double Action Operation
View Product DatasheetQR 6.36View Options
Cylinder Mounting Bracket
Vertical bracketing of the PCL-160, PCL-300 and PCL-460 is provided by the Model MB-15 bracket kit . Vertical bracketing of the PCL-600 is provided by the Model MB-1 bracket kit . These kits must be ordered separately with each cylinder/valve assembly. Cylinder installation instructions are provided in the installation section of this manual.
- Cylinder Bracket
- These kits must be ordered separately with each cylinder/valve assembly
- Cylinder installation instructions are provided in the installation section of this manual.
View Product DatasheetQR 276.00 – QR 290.00View Options
Firefighter telephone systems provide two-way communications for facilities where radio communications may not be available or are unreliable. They are typically used during active firefighting conditions, during a fire alarm investigation, or during fire alarm system inspection and test.
View Product DatasheetQR 720.00View Options
Coil Supervisory Module
Wired electrically before the actuator and located in the actuator wiring junction box. The connected RAC provides continuity supervision of the actuator coil and wiring and provides short circuit supervision to the coil supervision module.
View Product DatasheetQR 90.00View Options
Nozzles have been developed for appliance, plenum, and duct applications. All nozzles have a specific flow point value and are supplied with metal blow-off caps to prevent clogging. Each nozzle is stamped with the model number.
View Product DatasheetQR 148.00 – QR 158.00View Options
Female Screw Thread Adaptor
Available in Variable Sizes, Made in Aluminum Alloy and Copper Alloy
View Product DatasheetQR 234.00View Options
Single-gang size; includes 3 position contact block housing with 1 contact block UL, ULC, CSFM listed.
View Product DatasheetQR 442.00 – QR 636.00View Options
Photoelectric Smoke Detector ...
Photoelectric smoke sensitivity is selectable at the fire alarm control panel. The host control panel automatically compensates for sensitivity shifts caused by contamination and automatically reports dirty devices
- Louvered design enhances smoke capture by directing flow to chamber
- Photoelectric sensor
- Photoelectric smoke sensitivity is selectable
- UL listed
View Product Datasheet FLKFDB0004QR 125.00View Options
Weatherproof Back Box for Pul...
- Weather-proof surface mount cast aluminum box,
- Suitable for outdoor applications
View Product DatasheetQR 188.40View Options
Automatic Heat Detector
Explosion-proof for installation in hazardous locations. Has hexagonal grip bushing with 1/2’ conduit threads for attachment to threaded hub cover of series JL fixture fitting
View Product DatasheetQR 229.00View Options
Standard Type Nozzle Diffuser. Made in Aluminum Alloy
View product DatasheetQR 66.20View Options
Multi-candela strobe with intensity selectable as: 15, 30, 75, or 110 candela; synchronized flash rate.
- Simplex fire alarm control panels with NACs selected to provide strobe synchronization or SmartSync two-wire control
- Ceiling mount strobes installed using standard single gang electrical boxes.
- Rear of housing does not extend into box
View Product DatasheetQR 158.03View Options
Hose Male Adaptor
The male pilot hose connector is used to connect two pilot hoses together for systems where a second container of a different size is used to protect a different enclosure.
View Product DatasheetQR 0.00 – QR 34.00View Options
This Actuator is Used for mechanical or pneumatic operating system at the container position and is fitted to the top of the valve assembly or removable electrical actuator.
View product DatasheetQR 370.00 – QR 525.00View Options
Manifold inlets are available for the construction of system manifolds. Threaded Inlet for Manifolds
View Product DatasheetQR 440.00View Options
Manifold Check Valve
Check valves are generally installed in pipelines to prevent backflow. A check valve is basically a one-way valve, in which the flow can run freely one way, but if the flow turns the valve will close to protect the piping, other valves, pumps .
View Product DatasheetQR 760.00 – QR 980.00View Options
Discharge Nozzle Brass
FM-200® is distributed within the protected area by the discharge nozzle which is sized to ensure the correct flow of agent for the risk. Nozzles are supplied as standard in Brass as BSPP or NPT with Stainless Steel as an option
View Product DatasheetQR 240.00 – QR 410.00View Options