-
Replacement Break Glass
Double Action Stations (Breakglass) requires the operator to strike the front-mounted hammer to break the glass and expose the recessed pull lever. The pull lever then operates as a single action station.
- Replacement break glass
- Non-Coded, Non-Addressable Manual Stations; 2099 Series Single and Double Action Operation
View Product Datasheet
QR 6.36View Options -
Mounting Feet
To fasten the fan on the floor or to the ceiling. Manufactured in steel sheet and protected against atmospheric agents by epoxy paint.
View Product Datasheet
-
Fire Telephone
Firefighter telephone systems provide two-way communications for facilities where radio communications may not be available or are unreliable. They are typically used during active firefighting conditions, during a fire alarm investigation, or during fire alarm system inspection and test.
View Product Datasheet
QR 720.00View Options -
Double Action Pull Station
Manual release station, red housing with white letters and white pull lever Requires label kit
View Product Datasheet
QR 63.11View Options -
Coil Supervisory Module
Wired electrically before the actuator and located in the actuator wiring junction box. The connected RAC provides continuity supervision of the actuator coil and wiring and provides short circuit supervision to the coil supervision module.
View Product Datasheet
QR 90.00View Options -
Abort Switch
Single-gang size; includes 3 position contact block housing with 1 contact block UL, ULC, CSFM listed.
View Product Datasheet
-
Photoelectric Smoke Detector ...
Photoelectric smoke sensitivity is selectable at the fire alarm control panel. The host control panel automatically compensates for sensitivity shifts caused by contamination and automatically reports dirty devices
- Louvered design enhances smoke capture by directing flow to chamber
- Photoelectric sensor
- Photoelectric smoke sensitivity is selectable
- UL listed
View Product Datasheet FLKFDB0004
QR 125.00View Options -
Weatherproof Back Box for Pul...
Model: 2975-9211
- Weather-proof surface mount cast aluminum box,
- Suitable for outdoor applications
View Product Datasheet
QR 188.40View Options -
Multi-Candela Strobes
Multi-candela strobe with intensity selectable as: 15, 30, 75, or 110 candela; synchronized flash rate.
- Simplex fire alarm control panels with NACs selected to provide strobe synchronization or SmartSync two-wire control
- Ceiling mount strobes installed using standard single gang electrical boxes.
- Rear of housing does not extend into box
View Product Datasheet
QR 158.03View Options -
Centrifugal Fans – Forw...
The fans of the AL series find their principal application in the civil and industrial ventilation plants, heating and conditioning.
View Product Datasheet
QR 5,260.00View Options -
Centrifugal In-Line Fans Roun...
The AXC LINE-METAL is a series of centrifugal in-line fans with the advantage, typical of axial fans, to convey air along the same axis of the impeller
View Product Datasheet
QR 588.00 – QR 646.00View Options -
Plate Mounted Axial Fans
The QCM series are axial fans suitable for application on wall or panel in residential, commercial and industrial building.
View Product Datasheet
-
Gravity Shutters
Gravity Shutters avoids heat loss and entry of wind, rain, and birds. The fins of the shutter are opened by the airflow when the fan is working and they close down by gravity when the fan is switched off.
View Product Datasheet
QR 302.00 – QR 485.00View Options -
-
Centrifugal Inline Fans
The TMF is a series of centrifugal in-line fans with the advantage, typical of axial fans, to convey air along the same axis of the impeller. The low noise level and the good pressure head make them ideal for industrial and residential installations. They are suitable to convey clean air up to a maximum temperature of 40°C.
View Product Datasheet
QR 490.00View Options -
Flashing Strobe
TrueAlert ES addressable strobes are individually addressed visible notification appliances that receive power, supervision, and control signals from the Simplex fire alarm control panel providing IDNAC Signaling Line Circuits (SLCs).
View Product Datasheet
QR 141.60View Options -
Centrifugal Roof Extractors
Centrifugal roof fans are designed for direct or ducted ventilation in residential, commercial, and industrial buildings. they are designed for easy installation, high-efficiency low noise levels. The motor is outside the airflow, this allows the fan to exhaust clean or slightly dusty air with temperature
View Product Datasheet
-
Inlet Cone
It allows a higher fan efficiency in case of installation with an inlet or outlet not ducted. Manufactured in steel sheet, with one flange according to UNI ISO6580 – EUROVENT to be fitted to the CC fan, and an aerodynamically shaped bell mouth, with fixing holes for a protection guard Protected against atmospheric agents by epoxy paint.
View Product Datasheet
QR 1,365.00View Options -
Master Fire Telephone
Master Telephone with Control Module, three Class B telephone NACs Module and three Class B telephone NACs, one maximum per audio system.
View Product Datasheet
QR 1,404.00View Options -
Ultra-Slim Wall Axial Fans
To exhaust air directly to the outside or into a short length ducting (max 3 m length). Suitable for toilets, bathrooms, WC’s, shower-rooms, utility rooms, and kitchens
View Product Datasheet
QR 176.00 – QR 346.00View Options -
GRID SS-BOX 315, PROTECTION G...
Main structure in galvanized steel sheet, inside lined with extra-thick acoustic insulation to minimize noise and ensure the silence of fan operation when placed inside.
SS-BOXED fans are suitable for being installed in small exhausting plants, where limited dimensions and easy installation are also required.
View Product Datasheet
QR 110.00 – QR 125.00View Options