-
Vertical Multistage Inline Pump
Multi-speed vertical high-pressure centrifugal pump with stainless steel impellers and cast iron pedestal.
View Product Datasheet
QR 1,645.00 – QR 2,980.00View Options -
Multistage, Horizontal High-P...
The pumps of the BM range are non-self-priming, horizontal, multistage, end-suction centrifugal pumps. The pumps are of the close-coupled type. The pumps have a radial suction and an axial discharge branch and are fitted to a low-profile base plate. The BM pumps are unique products that have been developed in order to fulfill a wide variety of customer demands. Those pumps are available in various sizes and numbers of stages in order to cover a wide flow and pressure range.
View Product Datasheet
QR 2,280.00 – QR 4,410.00View Options -
Rubber Support Inserts
Used at the supporting points of insulated pipes to prevent crushing of insulation. Available with steel reinforcements for larger sizes. Inherently superior to wood .
View Product Datasheet
QR 1.46 – QR 131.31View Options -
U Strap With EPDM Lining
A Standard Pipe Strap with lining is recommended for supporting a piping system with fittings vertically or horizontally to walls or ceilings. It can be used as a restrainer when installed on top of structural wood beams for beam, for limiting pipe movements due to thrust loads during sprinkler system start-up.
View Product Datasheet
QR 1.59 – QR 10.29View Options -
U Strap
A Standard Pipe Strap is recommended for supporting a piping system with fittings vertically or horizontally to walls or ceilings. It can be used as a restrainer when installed on top of structural wood beams for beam, for limiting pipe movements due to thrust loads during sprinkler system start-up.
View Product Datasheet
QR 2.40 – QR 9.00View Options -
U Bolts with Lining
U-Bolts with lining are used to secure piping to structural members.
QR 3.22View Options -
U Bolt with 4 nuts
U-Bolts are used to secure piping to structural members.
View Product Datasheet
QR 2.40 – QR 10.55View Options -
Clevis Hanger
A Clevis Hanger provides for sizeable loads to be supported and for an elevation adjustment depending upon the pipe diameter. The lower nut adjusts the piping to the proper elevation and the upper nut, when locked into position, prevents loosening due to vibration.
View Product Datasheet
QR 1.63 – QR 20.93View Options -
Sprinkler Pipe Hanger
A Sprinkler Hanger recommended to provide vertical support to non insulated piping systems. By adjusting the position of the sprinkler nut on the hanger rod at the top of the hanger, pipe elevation can be altered.
View Product Datasheet
QR 0.99 – QR 5.71View Options -
Pipe Hanger with EPDM Lining
PIPE HANGER WITH EPDM LINING is recommended for non-insulated stationary pipelines in a horizontal position. It can be used for supporting pipes along with the roof.
View Product Datasheet
QR 0.65 – QR 3.28View Options -
O- Ring
O rings are used to block a path that may otherwise allow a liquid or a gas to escape. The o ring is placed into a groove to secure them in place, and then compressed between two surfaces
View Product Datasheet
QR 224.00View Options -
Submersible Pump
Wastewater and sewage pumps with an in-built macerator system. Enable pumping of fecal matter into small pressure pipes (DN40)
View Product Datasheet
QR 4,765.00View Options