-
Grooved Check Valve
The TYCO Model CV-1F Grooved End Swing Check Valves are compact and rugged swing-type units that allow water flow in one direction and prevent flow in the opposite direction.
View Product Datasheet
QR 525.00 – QR 1,245.00View Options -
Carrier Wall split unit 1.5 t...
High Wall split unit , 2 TR / 6 star / R-410 a refrigerant / Rotary Compressor View Product Datasheet
QR 2,280.00 – QR 2,850.00View Options -
Carrier Wall split unit 2.5 ton
High Wall split unit Model No 38KHB030HN/42KHB030HN , 2.5TR / 6 star / R-410 a refrigerant / Rotary Compressor View Product Datasheet
QR 3,925.00View Options -
Water Flow Switch
The Potter VSR is a vane-type Waterflow switch with a non-corrosive insert for use on wet sprinkler systems.
- The Potter VSR is a vane type water flow switch with non-corrosive insert for use on wet sprinkler systems.
- It is UL Listed and FM Approved for use on steel pipe.
- Non – corrosive sleeve factory installed in saddle
View Product Datasheet
QR 342.00 – QR 435.00View Options -
Pressure Switch
The Potter PS10 Series Pressure Actuated Switches are designed for the detection of a water flow condition in automatic fire sprinkler systems of particular designs such as wet pipe systems with alarm check valves, dry pipe, preaction, or deluge valves.
View Product Datasheet
-
Pressure Reducing Valve
Cla-Val 90-21 Pressure Reducing Valves are indispensable in any fire protection system.
- Globe or Angle Pattern
- Proven Reliable Design
- Available in Cast Bronze, Ductile Iron and Cast Steel
- Accurate Pressure Control
- In Line Service
- Grooved Ends
View Product Datasheet
-
Wet Alarm Valves
The TYCO Model Alarm Check Valves are intended for use in wet pipe (automatic sprinkler) fire protection systems.
View Product Datasheet
QR 1,213.00 – QR 2,685.00View Options -
Discharge Nozzle Brass
FM-200® is distributed within the protected area by the discharge nozzle which is sized to ensure the correct flow of agent for the risk. Nozzles are supplied as standard in Brass as BSPP or NPT with Stainless Steel as an option
View Product Datasheet
QR 345.00View Options -
Refrigeration Copper Coils
Copper Pipes & Coils manufactured to ASTM B743 standards are suitable for gas applications and other high-pressure refrigerants.
ACR Copper Coils & Pipes are dehydrated, degreased, purged with nitrogen, and capped to maintain the internal cleanliness of the product.
Coil Length: 15 meters
View Product Datasheet
-
-
Tamper Switch
The OSYSU is used to monitor the open position of an OS&Y (outside screw and yoke) type gate valve.
The Model PCVS is a weather proof and tamper resistant switch for monitoring the open position of fire sprinkler control valves of the wall and yard post indicator and butterfly types
QR 210.00View Options -
Butterfly Valve Grooved End
The TYCO Models BFV-300 and BFV300C Grooved End Butterfly Valves are indicating type valves designed for use in fire protection systems where a visual indication of open or closed valve condition is required
- Designed for use in fire protection systems
- UL and ULC Listed
- FM Approved
View Product Datasheet
QR 756.00 – QR 1,435.00View Options -
Hose Male Adaptor
The male pilot hose connector is used to connect two pilot hoses together for systems where a second container of a different size is used to protect a different enclosure.
View Product Datasheet
QR 43.00View Options -
Manual/Pneumatic Actuator
This Actuator is Used for mechanical or pneumatic operating system at the container position and is fitted to the top of the valve assembly or removable electrical actuator.
View product Datasheet
QR 334.00View Options -
Supervisory Pressure Switch
A low pressure warning switch is fitted to every container and must be ordered separately. The device continuously monitors the container pressure and in the event of the pressure dropping below 20 bar (290 psi) the switch operates to enable the condition to be signaled to a control unit
View Product Datasheet
QR 157.00View Options -
Manifold Inlet
Manifold inlets are available for the construction of system manifolds. Threaded Inlet for Manifolds
View Product Datasheet
-
Bladder Expansion Tank
Intended for use in hydronic heating systems, these tanks accept the expanded volume of hot water keeping the system pressure below the relief valve setting, thus preventing dangerous pressure build-up.
View Product Datasheet
QR 12,200.00 – QR 13,500.00View Options -
Trim Vertical Closed Drain Co...
The TYCO Series “Royal Flush II” Concealed Pendent Sprinklers Quick Response (3-mm bulb) and Standard Response (5-mm bulb), are decorative sprinklers featuring a flat cover plate designed to conceal the sprinkler.
The TYCO Model RC-1 Retard Chamber is required in installations that will be subject to pressure variations, as are generally associated with public water supplies, in order to help prevent false alarms.
- Quick & Standard Response, Standard Coverage
- Designed to conceal the sprinkler.
- UL Listed and FM Approval
View Product Datasheet RFII
-
Valve Single Tank Adaptors
When a single 343 litre container is being used without a manifold, three swivel adaptors are available for connection to the discharge outlet
View Product Datasheet
-
Deluge Valve, Diaphragm Style
The DV-5 Deluge Valve is a diaphragm style valve that depends upon water pressure in the Diaphragm Chamber to hold the Diaphragm closed against the water supply pressure. These valves are to be used only for hydraulically calculated systems.
View Product Datasheet
QR 3,882.00View Options -
Pressure Independent Control ...
FLOWCON PRESSURE INDEPENDENT CONTROL VALVE, FIXED FEMALE BY FEMALE THREADED, PRESSURE/TEMPERATURE PLUGS (STANDARD) HIGH FLOW
The Flowcon PICV is designed as a 3-in-1 solution combining a full stroke modulation control valve, an automatic balancing valve, and a differential pressure control valve
View Product Datasheet
-
Extended Coverage Horizontal ...
TYCO Series Extended Coverage Horizontal Sidewall Sprinklers Quick and Standard Response (Light Hazard) are decorative 3 mm glass bulb type spray sprinklers designed for use in hydraulically calculated sprinkler systems in light hazard, commercial application
View Product Datasheet
QR 40.00 – QR 45.00View Options -
Bye-Pass Assembly
For either system by-pass application, Flowcon recommends a combination of automatic/dynamic balancing and 3-way control with focus on indoor climate and reduced energy consumption FLOWCON FCU LINK WITH BYPASS ISOLATION VALVES, IVC STRAINER, AND FLOWCON PICV FIXED FMXFM WITH P/T PLUGS, SS FLEXIBLE CONNECTOR & INSULATION
View Product Datasheet BY-PASS ASSY