-
Fire Telephone
Firefighter telephone systems provide two-way communications for facilities where radio communications may not be available or are unreliable. They are typically used during active firefighting conditions, during a fire alarm investigation, or during fire alarm system inspection and test.
View Product Datasheet
QR 720.00View Options -
Double Action Pull Station
Manual release station, red housing with white letters and white pull lever Requires label kit
View Product Datasheet
QR 63.11View Options -
Coil Supervisory Module
Wired electrically before the actuator and located in the actuator wiring junction box. The connected RAC provides continuity supervision of the actuator coil and wiring and provides short circuit supervision to the coil supervision module.
View Product Datasheet
QR 90.00View Options -
Abort Switch
Single-gang size; includes 3 position contact block housing with 1 contact block UL, ULC, CSFM listed.
View Product Datasheet
QR 442.00 – QR 636.00View Options -
Photoelectric Smoke Detector ...
Photoelectric smoke sensitivity is selectable at the fire alarm control panel. The host control panel automatically compensates for sensitivity shifts caused by contamination and automatically reports dirty devices
- Louvered design enhances smoke capture by directing flow to chamber
- Photoelectric sensor
- Photoelectric smoke sensitivity is selectable
- UL listed
View Product Datasheet FLKFDB0004
QR 125.00View Options -
Weatherproof Back Box for Pul...
Model: 2975-9211
- Weather-proof surface mount cast aluminum box,
- Suitable for outdoor applications
View Product Datasheet
QR 188.40View Options -
Multi-Candela Strobes
Multi-candela strobe with intensity selectable as: 15, 30, 75, or 110 candela; synchronized flash rate.
- Simplex fire alarm control panels with NACs selected to provide strobe synchronization or SmartSync two-wire control
- Ceiling mount strobes installed using standard single gang electrical boxes.
- Rear of housing does not extend into box
View Product Datasheet
QR 158.03View Options -
Universal Base for Fire Detec...
The USB 502 detector base series is used for connecting and mounting the SecuriStar detector family and is completely compatible with the USB 501 detector base series, although this series has a larger connection compartment inside the base. A 6-pin terminal block is present in the interior of the USB 502 for connecting the base to the fire detectors. If necessary, an additional 4-pin terminal block can be fitted in the corresponding snap-in holder to create support points. The detector is fixed in the USB 502 by means of a bayonet connection.
View Product Datasheet
QR 12.11 – QR 82.00View Options -
Flashing Strobe
TrueAlert ES addressable strobes are individually addressed visible notification appliances that receive power, supervision, and control signals from the Simplex fire alarm control panel providing IDNAC Signaling Line Circuits (SLCs).
View Product Datasheet
QR 141.60View Options -
Master Fire Telephone
Master Telephone with Control Module, three Class B telephone NACs Module and three Class B telephone NACs, one maximum per audio system.
View Product Datasheet
QR 1,404.00View Options