-
Test and Drain Valve
The test and drain valve complies with NFPA13 sprinkler systems. Inspector’s test and drain unit w/on-off unit with brass sight glass. Female NPT inlet and outlet cast brass valve.
View Product Datasheet
QR 595.00View Options -
Bladder Expansion Tank
Intended for use in hydronic heating systems, these tanks accept the expanded volume of hot water keeping the system pressure below the relief valve setting, thus preventing dangerous pressure build-up.
View Product Datasheet
QR 12,200.00 – QR 13,500.00View Options -
Wet Chemical Fire Extinguishers
Wet chemical extinguishers are the best restaurant kitchen appliance hand portable fire extinguishers.
- All metal valve construction
- Swivel connection on hose allows nozzle to be oriented for proper use
- Nozzle grip design with 45° angle for easy “overhead” application
- Low PH agent discharged as fine mist helps prevent grease splash and re-flash while cooling the appliance
- Precise extinguishing agent application no dry chemical to clean up
- Excellent for use on all cooking appliances including solid fuel charbroilers
- Tested on commercial deep fat fryers to ul 711 test protocol and safe to use on class c fires
- Class 2a rated to meet fire code occupancy hazard requirements
- Bar coded and bi-lingual labels
View Product Datasheet
QR 280.00View Options -
DZR Brass Float Valve
DZR Brass Float Valve. Supplied with locknut. Machined fixed flange on the valve body. No jam single lever action.
View Product Datasheet
QR 151.00View Options -
Wet Chemical Fire Extinguishers
Wet Chemical Fire Extinguishers use a film forming base with additional chemicals and micro drop mist nozzle technology. The agent forms a mild foam surface over the hot oil but not a crust or foam mess like most other agents. The extinguishing is through smothering initially and cooling through heat absorption through high volume micro drops and a chemical reaction.
CLASSES OF FIRE
View Product Datasheet
QR 280.00View Options -
Extention Split Pipe Clamp
Material: Malleable Iron
Function: Designed for suspending non-insulated pipe horizontally or vertically.
Approvals: Conforms to Federal Specification WW-H-171E & A-A-1192A, Type 25 and Manufacturers Standardization Society ANSI/MSS SP-69 & SP-58, Type 12.
Standard Finish: Plain or Electro-Galvanized.View Product Datasheet
QR 3.85 – QR 26.50View Options -
Rubber Lined Split Clamp
Standard finish: Electro-zinc plated complies with ASTM B633
Function: Designed for suppressing vibration and soundView Product Datasheet
-
U Bolt with 4 nuts
Heavy-duty U-Bolts designed to grip, guide or support plain and insulated pipes. Supplied complete with four nuts
View Product Datasheet
-
Riser Clamp
A Riser clamp is a type of hardware used by mechanical building trades for pipe support in vertical runs of piping (risers) at each floor level. The devices are placed around the pipe and integral fasteners are then tightened to clamp them onto the pipe.
View Product Datasheet
QR 14.30 – QR 131.00View Options -
Short Insulation Protection S...
Function: Designed for protection of foam, fiberglass, or any high density insulation when used with pipe hangers.
Finish: Pre-GalvanizedView Product Datasheet
-
Cleivis Hanger
A Clevis Hanger provides for sizeable loads to be supported and for an elevation adjustment depending upon the pipe diameter. The lower nut adjusts the piping to the proper elevation and the upper nut, when locked into position, prevents loosening due to vibrati
View Product Datasheet
QR 2.86 – QR 99.50View Options